[Nov-2024] H12-811_V1.0 Free Sample Questions to Practice One Year Update
Download H12-811_V1.0 exam with Huawei H12-811_V1.0 Real Exam Questions
The H12-811_V1.0 exam covers a wide range of topics related to data communication, including networking fundamentals, LAN switching technologies, WAN technologies, network security, IP routing technologies, and network virtualization. Candidates who pass H12-811_V1.0 exam will have a comprehensive understanding of Huawei's data communication products and solutions and will be able to design and deploy network solutions that meet the needs of businesses of various sizes and industries.
NEW QUESTION # 362
SNMPv1 defines five protocol operations. ()
- A. True
- B. False
Answer: A
NEW QUESTION # 363
Which of the following IPv6 addresses is a multicast address? ()
- A. FE80:2EO:FCFF:FEEF:FEC
- B. FF02::2EO:FCFF:FEEF:FEC
- C. 2000::2EO:FCFF:FEEF:FEC
- D. FC0O:2EO:FCFF:FEEF:FEC
Answer: B
NEW QUESTION # 364
AC. Use CAPWAP control tunnel to transmit management messages to FIT AP. ()
- A. True
- B. False
Answer: A
NEW QUESTION # 365
All interfaces of routers running OSPF must belong to the same area.
- A. True
- B. False
Answer: B
NEW QUESTION # 366
The network is shown in the figure below. The router uses a sub-interface as the host gateway. The gateway IP address is 10.0.12.2. Which of the following commands can achieve this requirement? () (Multiple Choice Questions)
- A. interface GigabitEthernet0/0/0.10Dotlq termination vid 10
Ip address10.0.12.2255.255.255.0 Arp broadcast enable # - B. interface GigabitEtherneto/0/0.10Dotlq termination vid 20
Ip address10.0.12.2255.255.255.0Arp broadcast enable - C. interface GigabitEthernet0/0/0.20Dotlq termination vid 20
Ip address10.0.12.2255.255.255.0Arp broadcast enable # - D. interface GigabitEthernet0/0/0.20Dotlg termination vid 10
Ip address10.0.12.2255.255.255.0Arp broadcast enable
Answer: B,C
NEW QUESTION # 367
As shown in the figure, router A has successfully telneted to router B using 10.0.12.2. Which of the following operations will interrupt the Telnet session between router A and router B?
- A. Disable G0/0/1
- B. Enable OSPF on G0/0/1
- C. Change the IP address of G0/0/1
- D. Configure a static route
Answer: A,C
NEW QUESTION # 368
On the VRP platform, the priority of the default protocol for direct routing, static routing, RIP, and OSPF routing in the area is from high to low.
- A. Direct routing, static routing, RIP, OSPF
- B. Direct routing, OSPF, RIP, static routing
- C. Direct routing, RIP, static routing, OSPF
- D. Direct routing, OSPF, static routing, RIP
Answer: D
NEW QUESTION # 369
In an IPv4 network, AP supports static and DHCP methods to obtain IP addresses.
- A. True
- B. False
Answer: A
NEW QUESTION # 370
Only the WPA2-PSK security policy supports the use of TKIP for data encryption. ()
- A. True
- B. False
Answer: A
NEW QUESTION # 371
The priority of the LACP protocol is shown in the figure. Switch A and Switch B adopt LACP mode link aggregation. And all interfaces join the link aggregation group. At the same time, set the maximum number of active ports to 3. Then which port of switch A is not the active port?
- A. G0/0/2
- B. G0/0/3
- C. G0/0/0
- D. G0/0/1
Answer: B
NEW QUESTION # 372
The device port running the STP protocol is in the Forwarding state. Which of the following statements are correct? ()
- A. The port not only does not process BPDU packets, but also does not forward user traffic
- B. This port only receives and processes BPDUs, and does not forward user traffic
- C. This port port not only forwards user traffic but also processes BPDU packets
- D. The port will construct a MAC address table based on the received user traffic, but does not forward user traffic
Answer: C
NEW QUESTION # 373
In the network shown in the figure below, which of the following commands can be entered on the router to enable host A to ping host B?
- A. RTA: ip route-static 10.0.12.5 255.255.255.252 11.0.12.1 RTB:: ip route-static 10.0.12.1
255.255.255.252 11.0.12.2 - B. RTA: ip route-static 0.0.0.0 0.0.0.0 11.0.12.2 RTB:: ip route-static 0.0.0.0 0.0.0.0 11.0.12.1
- C. RTA: ip route-static 10.0.12.5 255.255.255.252 11.0.12.2 RTB:: ip route-static 10.0.12.1
255.255.255.252 11.0.12.1 - D. RTA: ip route-static 0.0.0.0 0.0.0.0 11.0.12.1 RTB:: ip route-static 0.0.0.0 0.0.0.0 11.0.12.2
Answer: B,C
NEW QUESTION # 374
When the lease period reaches what percentage does the DHCP client send the lease renewal message for the first time? ()
- A. 0.25
- B. 0.5
- C. 0.875
- D. 0
Answer: B
NEW QUESTION # 375
Which of the following statements about RA.
and RS messages in IPv6 are correct? ()*
- A. RA. Used to reply address prefix information
- B. RS is used to reply address prefix information
- C. RS is used to request address prefix information
- D. RA. Used to request address prefix information
Answer: A,C
NEW QUESTION # 376
The following two configuration commands can realize the router RTA.
The main and backup backup routes to the same destination 10.1.1.0: () (RTA)ip route--statiC.10.1.1.02412.1.1.1 permanent(RTA)ip route--statiC.10.2.2.02413.1.1.1.
- A. True
- B. False
Answer: B
NEW QUESTION # 377
When planning a campus network, you can plan VLANs according to business types.
- A. True
- B. False
Answer: A
NEW QUESTION # 378
When learning this switch needs to forward the frame with the destination MAC. The address is 5489-98ec-f011, the following description is correct ()
- A. The switch will send a message that the destination is unreachable to the source device
- B. The switch needs to discover the MAC by sending a request..Device with address 548998ec-f011
- C. The switch does not find a matching entry in the MAC. address table, so the frame will be discarded
- D. The switch will flood the frame on all ports except the port that received the frame
Answer: D
NEW QUESTION # 379
In order to distinguish different users and provide different network services on the AP, which of the following can be configured?
- A. VAP
- B. WAP
- C. VAC
- D. VT
Answer: A
NEW QUESTION # 380
As shown in the figure below, all hosts can communicate normally, is the corresponding relationship between SWA MAC address and port correct?
- A. MAC-AG0/0/1 MAC-B G0/0/2 MAC-C G0/0/1
- B. MAC-A G0/0/1 MAC-B GO/0/1 MAC-C G0/0/3
- C. MAC-A G0/0/1 MAC-B G0/0/2 MAC-C G0/0/3
- D. MAC-A G0/0/2 MAC-B G0/0/2 MAC-C G0/0/3
Answer: C
NEW QUESTION # 381
Which of the following IE802.11 standards only supports the 24GHz frequency band for communication? ()
- A. 802.11g
- B. 802.11a
- C. 802.11ax
- D. 802.11n
Answer: A
NEW QUESTION # 382
Which of the following descriptions of wireless devices is correct?
- A. FIT AP independently completes user access, authentication, service forwarding and other functions, and FAT AP works in conjunction with wireless controllers.
- B. The wireless device does not have a wired interface
- C. The wireless controller AC is generally located at the convergence layer of the entire network, providing high-speed, safe and reliable WAN services
Answer: C
NEW QUESTION # 383
When we search for accessible wireless networks on our laptop, what is the actual network name displayed?
- A. BSSID
- B. SSID
- C. BSS
- D. ESS
Answer: B
NEW QUESTION # 384
On the switch, which VLANs can be deleted by using the undo command?
- A. vlan1024
- B. vlan4094
- C. v1an1
- D. vlan2
Answer: A,B,D
NEW QUESTION # 385
Currently, the company has a network administrator, and the AR2200 in the company network can be remotely managed by directly entering the password through Telnet. After the two new network administrators arrived, the company hopes to assign their own user names and passwords to all the administrators, as well as different levels of authority. So how should it be done? ()
- A. Each administrator uses a different public IP address of the device when running the Telnet command
- B. Configure three user names and their corresponding passwords in the AAA. view
- C. When configuring each administrator's account, different permission levels need to be configured
- D. The user authentication mode configured by Telnet must be AAA.
Answer: B,C,D
NEW QUESTION # 386
Which of the following fields is not included in the He1lo packet of the OSPF protocol? ()
- A. HelloInterval
- B. Network Mask
- C. Neighbor
- D. sysname
Answer: D
NEW QUESTION # 387
......
Huawei H12-811_V1.0 (HCIA-Datacom V1.0) Exam is a certification that is designed for professionals who want to demonstrate their expertise in data communication. H12-811_V1.0 exam covers a wide range of topics related to network architecture, protocols, security, and management. Candidates who pass H12-811_V1.0 exam earn the Huawei Certified ICT Associate in Datacom certification, which is recognized globally and is highly valued by employers.
Real exam questions are provided for HCIA-Datacom tests, which can make sure you 100% pass: https://braindumpsschool.vce4plus.com/Huawei/H12-811_V1.0-valid-vce-dumps.html